Kickstarter Lithium Battery Backup System

Battery Backup Power Kickstarter Title Image

Battery Backup Power, Inc. is raising capital to launch its Lithium uninterruptible power supply (UPS)/battery backup system product lineup in the United States after testing and negotiating with part suppliers. The design allows for both 12 volt DC input from a car or solar panel or 120 volt AC input from grid power for charging. Output will be 12 volt DC, 120 volt AC, and USB. Funds raised will initially go to producing the first 500 units with standard NEMA 5-15 receptacles (sockets required to power most consumer electronics in the United States) as well as UL testing and certification. The first units produced will be portable 500 watt maximum, 1,000 watt surge, 26 amp hour systems. The high amp hour rating of the Lithium battery/batteries will mean that electronics can be run for hours on battery power as opposed to just minutes. Lithium batteries are significantly lighter than Sealed Lead Acid (SLA) batteries typically found in UPS systems and typically last over 2,000 discharge/charge cycles (5.47 years if used every single day). Current Sealed Lead Acid (SLA) batteries typically only last around 300 discharge/charge cycles (0.82 years if used every single day). Battery Backup Power, Inc. is dedicated to continued research and development in green technology and green energy storage with a focus on putting it in the hands of consumers. For more information, call (855) 330-7799 or email engineering@batterybackuppower.com.

UPS for the LulzBot TAZ 5 3D Printer

This is the Battery Backup Power, Inc. Uninterruptible Power Supply or UPS for the LulzBot TAZ 5 3D Printer. It automatically corrects voltage problems that may damage or degrade the performance of your 3D printer and provides surge protection with temporary backup power for when power outages occur. This UPS is sized specifically for the LulzBot TAZ 5 and if fully charged at the time of an outage, it will run the TAZ 5 for 6 minutes and 13 seconds on battery power. This gives the user time to start up a generator or safely power down the 3D printer.

http://www.backupbatterypower.com/products/bbp-1500ap-ssw-li-lulzbot-taz5

UPS for the MakerBot Replicator Z18 3D Printer

UPS for the MakerBot Replicator Z18 3D Printer

This is the Battery Backup Power, Inc. Uninterruptible Power Supply or UPS for the MakerBot Replicator Z18 3D Printer. It automatically corrects voltage problems that may damage or degrade the performance of your 3D printer and provides surge protection with temporary backup power for when power outages occur. This UPS is sized specifically for the MakerBot Replicator Z18 and if fully charged at the time of an outage, it will run the Z18 for 11 minutes and 31 seconds on battery power. This gives the user time to start up a generator or safely power down the 3D printer.

http://www.backupbatterypower.com/products/bbp-2000a-psw-li-mkrbt-rplctrz18