Don’t Lose Your 3D Print Job To A Brown Out Or Power Outage

Don’t lose your 3D print job to a brown out or power outage. Run Your MakerBot Replicator Mini, Replicator, Replicator Z18, Replicator 2, or Digitizer for over 30 minutes without power using a BBP-2000A-PSW-LI uninterruptible power supply.

http://www.backupbatterypower.com/products/intermediate-battery-backup-and-power-protection-ups-for-large-or-multiple-electronic-devices

Wait, what?

Wait, what?

An uninterruptible power supply with a larger VA from a competitor of Battery Backup Power, Inc. runs out of juice before a smaller Battery Backup Power, Inc. unit at the same load. How is this possible?

Our competitors went cheap on the number of batteries hoping a higher VA number distracted from the minimal run time.

An 850 VA / 510 Watt uninterruptible power supply with a single 12 Volt, 8.5 Amp Hour battery and a power factor of 0.6 from our competitor only runs 59% (7 minutes, 21 seconds) the time the Battery Backup Power, Inc. 600 VA / 360 Watt uninterruptible power supply with two 12 Volt, 7.2 Amp Hour batteries and a power factor of 0.6 runs with a 300 watt load (12 minutes, 26 seconds).

Smaller Battery Backup Power Unit Out Lives Larger Competitor
Smaller Battery Backup Power Unit Out Lives Larger Competitor

When The Power Goes Out, Battery Backup Power, Inc. Can Keep The Heat On.

Battery Backup Power Keeps The Heat On Image
When The Power Goes Out, Battery Backup Power, Inc. Can Keep The Heat On.

When The Power Goes Out, Battery Backup Power, Inc. Can Keep The Heat On.

Battery Backup Power, Inc. units BBP-6000-PSW-ONL, BBP-10000-PSW-ONL, BBP-15000-PSW-ONL, and BBP-20000-PSW-ONL can be installed by an electrician on a branch circuit to keep your heater running during a power outage. Call your state or utility company to see if subsidies are available.